1 inch tav on 3/4 axle?
Not real keen on selling/swapping it as the 6.5 is temporary till i buy an 8 or 9 with a 1 inch shaft.
Views: 45
Replies to This Discussion
-
Permalink Reply by Jonny Bravo on -
You could get someone to lathe up a sleeve to fit along the 3/4" shaft so that it makes it a 1". Use the keyway from the 3/4" shaft to keep it in place. You would just REALLY have to make sure it isn't brittle cause that would not end well for the winch and anyone near it :P.
PS Just remembered that may not even work cause when you bolt on a Tav, there is a threaded rod that you use to hold it in place which goes through the center of the shaft on the engine, and that probably will be too big for your 6.5hp engine (length and width wise). I had this problem when I bought an 8hp engine that was .5 of an inch too wide for my TAV, I was gonna lathe it down but I mean by the time you get all the machining done and everything (assuming you don't destroy your engine in the process) it ends up costing half the price of just buying a new engine :P
-
Permalink Reply by jake grimsey on -
Theres an 8hp briggs and stratton on ebay that would be sweet ay? Probs not as good as the honda but i dont have 700 bucks haha. Old mate said hed do 450 posted up here yea or nah?
dean butt said:jake just buy a different tav, there not that much
-
Permalink Reply by jake grimsey on
-
heres a picture of the shaft on the ebay motor.
if someone can tell me if they think this will do the trick or not that would be sweet as ill buy it tonight if it looks like it will work.
cheeeeers.
© 2012 Created by m@tt.
